Versalift LT-62-NE Telescopic Boom Aerial Bucket Truck on F550 For Sale

(1) 2015 Versalift Telescopic Boom Bucket Truck mounted on F550 for Sale

Original Owner - Owned Since NEW - Garage Kept - Low Hours and Miles!!

Only 6,388 Miles and 979 hours - Clean Machine - Ready to Work

PLATFORM
The standard platform is 49 in. x 33 in. x 43 in. (1.25 X 0.85 X 1.1m) (l x w x h) with a step-through opening for easy access. The maximum platform capacity is 440 lbs (200 kg). Platform leveling is controlled automatically by a master and slave cylinder arrangement and 180° hydraulic platform rotation is standard.

ROTATION
Rotation is continuous and unrestricted in either direction. An electric and hydraulic collector assembly provides the path for hydraulic oil and electric signals from the pedestal to the turret. A hydraulically driven worm and spur gear and a shear-ball rotation bearing accomplish rotation. The critical bolts holding the turret to the rotation bearing and the rotation bearing to the pedestal meet SAE grade 8 specifications. These critical bolts are Torque Seal Marked to provide a quick means to inspect for loosening. An adjustment screw is provided to adjust pinion and rotation gear clearances.

HYDRAULIC SYSTEM
The open center hydraulic system operates at 2250 psi (158 kg/cm2) at 3 gpm (11 lpm) . The pump draws oil through a 100 mesh suction strainer that is equipped with a bypass valve. A 10-micron return filter with a shut-off valve is included. This system is powered by the chassis transmission power take-off.

PAINTING
The complete unit was primed and painted before assembly. 

CYLINDERS
The extension cylinder has wear rings on the piston and end gland for extended seal life. Dual holding valves are mounted at the extension cylinder base to prevent boom creep during travel or uncontrolled movement in case of hydraulic hose failure. The boom elevation cylinder also has a dual holding valve.

EMERGENCY POWER
This system consists of a hydraulic pump driven by a DC motor, which is powered by the truck engine battery. The system is connected in parallel with the main pump and is designed for non-continuous operation. Toggle switches are used to energize the system at the upper and lower controls. Emergency power is only available when the primary power source is not operating.

BOOM & CYLINDER PINS
Pins are high-strength alloy steel and chrome plated for a hard finish and corrosion resistance. Cylinder pins are held in place with torque-marked bolts at one end and a pin cap bolted to the other end.

UPPER CONTROLS
The upper controls are mounted to the outside of the platform and include a guard to prevent damage and inadvertent operation. The boom functions are operated by fully feathering joysticks with safety triggers. Auxiliary functions are operated by color-coded push button switches. An emergency stop palm button is also provided. The emergency stop kills power to the controls, and control valve, and stops the chassis engine.

LOWER CONTROLS
The lower controls are mounted to the side of the turret. A key switch selects upper or lower control operation. Toggle switches operate all boom functions at reduced speeds. An emergency stop palm button is also provided. The emergency stop kills power to the controls, and control valve, and stops the chassis engine.

LUBRICATION
Fiberglass-Teflon non-lube bearings are used at all points of motion. The rotation bearing is the only component that requires periodic lubrication.