National Crane 647E2 Specifications
The National Crane 647E2 is no longer part of the 600E2 Series boom truck crane lineup. It is equipped with a 19-47 ft. (5.79-14.33 m) three-section telescopic boom. This model can be equipped with an 18-29 ft. (5.49-8.84 m) two-section jib for a maximum tip height of 86 ft. (26.24 m) with the 29 ft. (8.84 m) jib.
Best in class performance and serviceability
• The steel torsion box and flatbed further reduce frame flex
• Speedy-reeve boom tip and sheave blocks simplify rigging changes by decreasing the time needed to change line reeving
• Crane components painted before assembly reduce the chance of rust, improve serviceability and enhance the appearance of the crane
• A control knob located on the swing motor brake release valve can be easily adjusted to the crane operator’s swing speed preference
• Engine start/stop switches
• Emergency stop overrides located at the crane operator control station
• Hydraulic reservoir capacity of 66 gal
Serviceability
• Bearings on the boom and retract cables can be greased through access holes in the boom side plates.
• Removable winch allows the internal telescoping cylinder to be removed quickly, without dismantling the boom
• Internal anti-two-block wire routing eliminates external reel and wire to protect crane components
• The boom sheave case is open, allowing access to replace the internal anti-two-block wire and to observe internal boom components
• Internal boom parts have been reduced, decreasing service time when rebuilding the machine
Best in class performance and serviceability
• The steel torsion box and flatbed further reduce frame flex
• Speedy-reeve boom tip and sheave blocks simplify rigging changes by decreasing the time needed to change line reeving
• Crane components painted before assembly reduce the chance of rust, improve serviceability and enhance the appearance of the crane
• A control knob located on the swing motor brake release valve can be easily adjusted to the crane operator’s swing speed preference
• Engine start/stop switches
• Emergency stop overrides located at the crane operator control station
• Hydraulic reservoir capacity of 66 gal
Serviceability
• Bearings on the boom and retract cables can be greased through access holes in the boom side plates.
• Removable winch allows the internal telescoping cylinder to be removed quickly, without dismantling the boom
• Internal anti-two-block wire routing eliminates external reel and wire to protect crane components
• The boom sheave case is open, allowing access to replace the internal anti-two-block wire and to observe internal boom components
• Internal boom parts have been reduced, decreasing service time when rebuilding the machine
The National Crane 647E2 is still fully supported by a network of Manitowoc Group National Crane Distributors.